ACO-series Aquacon Fuel Monitor Cartridge

Welke lengte heeft u nodig?
U heeft 0 stuks nodig voor 0 euro incl. BTW
ACO-serie varianten
EUR 346,63 EUR 419,42 Incl. BTW
Zet op verlanglijstje
Bekijk onze winkels
Op bestelling
Toevoegen aan favorieten

Waarom Dial:

  • Groot assortiment
  • Eerlijk en goed advies
  • Ruim 17.000 artikelen op voorraad
  • Voor 15:00 uur besteld, volgende werkdag in huis!
  • Levering op zaterdag mogelijk
  • € 250,- franco binnen Nederland
  • Artikelomschrijving & specificaties
  • Documenten
  • Veel gestelde vragen


Remove Water and Dirt from Jet Fuel and Avgas Outside-to-In Flow Cartridges.


  • Free and emulsified water removal to less than 5 ppm
  • 0.3 micron particle removal
  • Provides protection against “slugs” of water
  • Pressure increase signals need for cartridge change
  • Use with existing filter housings


Patented Aquacon® Filter Cartridges have a unique high-capacity inner absorbent medium which removes all free and emulsified water from hydrocarbon fuels down to less than 5 ppm in the effluent. Absorbed water is chemically locked into this medium.

When a cartridge reaches its water holding capacity, its accordion pleats swell and cause an increase in the differential pressure which signals the operator to change the cartridge.

Solid contaminants are removed by the cartridge’s particulate filter media layers. The pleated accordion style design provides a large surface area for maximum dirt holding capacity. Models are offered for particle filtration down to 1/2 micron size with 98% plus efficiency. Performance is not affected by the presence of common surface active agents.

Compact Aquacon Cartridges are quick and easy to install. Models are available to fit most existing standard housings. Refer to Cartridge Selection Table on reverse side.

Use Form 1846 for cartridge changeout recommendations at flow rates less than rated flow.

Technical Information

  • Max. operating temp.: 160°F (71.1°C)
  • Micron ratings are nominal at 98%+ efficiency
  • Aquacon Cartridges can significantly reduce flow when loaded with water or dirt. Appropriate precautions should be taken in applications where fuel flow must be maintained or where surge conditions can occur.
  • Replace the cartridge if the differential pressure exceeds 25 psid. For service life information, please refer to Operating Procedure #1839 or consult your company fuel handling procedures.
  • Typical water holding capacity for ACO-61401P is 700-800 ml.

NOTE: 0.3 micron rated Aquacon® Cartridges are recommended for use with jet fuel and avgas. Effluent fuel quality meets requirements for EI 1583 7th Edition.




Helicopter Refueling
Maximum Flow Rate (LPM)378
Collapse Pressure, bar6.9
Recommended changeout, bar1
Recommended changeout Aviation, bar1
Suitable forAvgas
Avgas 100LL
Jet Fuels
FunctionWater Absorbent
Solid Removal
Micron Rating0.5
Water removal free and emulsified < PPM5
Water removal dissolvedYes
I.D. Inches1.875
O.D. Inches5.625
O.A.L. Inches24.25
Collapse Pressure, psi100
Recommended changeout, PSID15
Recommended changeout Aviation, PSID15
End Cap ConfigurationOpen End
Maximum operating temperature (F)160
Maximum operating temperature (C)71.1
Maximum Flow Rate (USGPM)100
Type of Filter MaterialSuper-Absorbent Polymers (SAP)
CertificatesEI1583 7th Edition
MerkParker Velcon
CategorieFilters - Coalescers - Separators

Stel een vraag over dit artikel



Wis filters


20210619 06:05:17 PC01False0FalseTrue220102